how to use turcite and ab glue ?

To use Turcite B and AB glue, follow these steps:

1. Clean the surfaces: Ensure that the surfaces to be bonded are clean, dry, and free from any dirt, grease, or oil. Use a suitable solvent to clean the surfaces if necessary.

2. Apply primer (optional): If recommended by the manufacturer, apply a thin layer of primer to both surfaces. This will improve the adhesion between Turcite B and the surfaces.

3. Mix the AB glue: Turcite B is typically used with a two-part epoxy adhesive (AB glue). Follow the manufacturer's instructions to mix the epoxy adhesive properly. Usually, you need to mix equal parts of the resin and hardener.

4. Apply the adhesive: Apply a thin, even layer of the mixed AB glue to one of the surfaces. Use a brush or a spatula to spread the adhesive evenly. Make sure to cover the entire surface that will come into contact with Turcite B.

5. Place Turcite B: Carefully place the Turcite B onto the adhesive-coated surface. Make sure it aligns properly with the mating surface.

6. Apply pressure: Apply pressure to the Turcite B to ensure good contact with the adhesive. You can use clamps or weights to hold the Turcite B in place while the adhesive cures. Follow the recommended curing time provided by the adhesive manufacturer.

7. Clean up excess adhesive: After the adhesive has cured, remove any excess adhesive using a suitable solvent or by scraping it off carefully.

turcite-(5)

Note: It is essential to follow the manufacturer's instructions for both Turcite B and the AB glue you are using. Different products may have specific requirements and curing times.