To use a quartz Sight Glass, follow these steps: 1. Ensure that the sight glass is clean and free from any debris or contaminants. If necessary, clean the glass using a suitable solvent or cleaning agent. 
2. Inspect the sight glass for any cracks or damages. If any defects are found, replace the sight glass before proceeding. 3. Identify the appropriate location to install the sight glass. This is typically a section of the system where you want to visually inspect the flow or level of a fluid or gas. 4. Shut down the system or isolate the section where the sight glass will be installed. This is important to prevent any accidents or leaks during installation. 5. Install the sight glass into the system. Depending on the specific design of the sight glass, this may involve screwing it into a threaded connection or welding it into place. Follow the manufacturer's instructions for proper installation. 6. Once the sight glass is securely installed, ensure that all connections are tight and leak-free. 7. If necessary, open valves or restart the system to allow the fluid or gas to flow through the sight glass. 8. Observe the sight glass to visually inspect the flow or level of the fluid or gas. The transparent quartz material allows for clear visibility, even in high-temperature or corrosive environments. 9. Regularly monitor the sight glass for any changes or abnormalities. If any issues are detected, take appropriate action, such as adjusting flow rates or addressing any leaks. 10. Periodically clean the sight glass to maintain clear visibility. This may involve using a suitable cleaning agent or solvent and a non-abrasive cloth or brush. Note: It's important to always refer to the manufacturer's instructions and guidelines for the specific quartz sight glass being used, as installation and usage instructions may vary.
Hengshui Aohong Technology Co.,Ltd.
